How to Operate Spray Gun

2024-06-19

1. Suggested air pressure of 2.0-3.0 bar(30-43psi).

2. Recommended paint viscosity differs according to paint property and painting conditions,18±2 sec./Iwata cup#2is recommendable.

3. Keep fluid output as small as possible to the extent that the job will not be hindered.It will lead to better finishing with the optimization.

4. Set the spray distance from the gun to the work piece within the range of 200-250mm(8-10in).

5. The spray gun should be held so that it is over particular to the surface of the work piece at all times.

Then the gun should move in a straight and horizontal. Arcing the gun causes uneven painting.

Spray Gun Troubleshootings

How to Connect Spray Gun

Related Article

Pour remaining paint out after use, clean each each section of the spray gun with thinner.

Spray defined amount of thinner to clean fluid passages until clean enough.

Then clean with a soft cloth. If not, remaining paint in the fluid passages may damage the spray gun after solidification.

Cleaning and Maintenance of Spray Gun

Spray Gun Troubleshootings

1. Connect an air hose to air nipple tightly.

2. Connect a fluid hose or a container to fluid nipple tightly.

3. Flush the gun fluid passage with a compatible solvent.

4. Pour paint into container, test spray and adjust fluid output as well as pattern width.

How to Connect Spray Gun

Fire and Explosion
1. Spark and open flames are strictly prohibited.

Paints can be highly flammable and can cause fire.

Spray Gun Operation Safety Precautions