Pour remaining paint out after use, clean each each section of the spray gun with thinner.

Spray defined amount of thinner to clean fluid passages until clean enough. 

Then clean with a soft cloth. If not, remaining paint in the fluid passages may damage the spray gun after solidification.

1. Fluttering

1. Suggested air pressure of 2.0-3.0 bar(30-43psi).

2. Recommended paint viscosity differs according to paint property and painting conditions,18±2 sec./Iwata cup#2is recommendable.

1. Connect an air hose to air nipple tightly.

2. Connect a fluid hose or a container to fluid nipple tightly.

3. Flush the gun fluid passage with a compatible solvent.

4. Pour paint into container, test spray and adjust fluid output as well as pattern width.

Fire and Explosion
1. Spark and open flames are strictly prohibited.

Paints can be highly flammable and can cause fire.